Plastic tube produced by blow molding

Details Plastic tube produced by blow molding Plastic tube produced by blow molding

B - Operations, Transporting

65

D

B65D 35/08 (2006.01) B29C 49/48 (2006.01) B29D 23/20 (2006.01) B65D 35/02 (2006.01) B65D 35/12 (2006.01)

Patent

CA 2059168

ABSTRACT A plastic tube produced by blow molding has a main section with an essentially constant cross-section over its length, which is formed by an even number of level wall sections. The wall sections are located opposite to each other and preferably have the same width. At the front end of the main section there is a tubular opening section with a smaller diameter than that of the main section. The rear and the main section converges to an essentially straight end edge which lies in a plane extending through the central longitudinal axis of the main section and which joins two longitudinal edges of the main section to form the end edge.

Affiliated with

Also associated with

Rating

Plastic tube produced by blow molding does not yet have a rating. At this time, there are no reviews or comments for this patent.

If you have personal experience with Plastic tube produced by blow molding, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Plastic tube produced by blow molding will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFCA-PAI-O-1933371