Manufacturing of positive power opthalmic lens

Details Manufacturing of positive power opthalmic lens Manufacturing of positive power opthalmic lens

G - Physics

02

C

G02C 7/06 (2006.01) B29D 11/00 (2006.01) G02B 1/00 (2006.01)

Patent

CA 2344329

Multifocal ophthalmic lenses may be manufactured by either injection molding and casting methodologies. The use of two opposed tools (mold faces) with relatively centered faces, but with significantly differing diameters can be used to provide multifocal ophthalmic lenses. The process is surprisingly capable of providing multifocal lenses with good control of the thickness of the lenses, with relatively thin center thicknesses (e.g., less than 4.7 mm, or less than 3.5 mm) and relatively thin edge thicknesses (e.g., 0.5 to 2.5 or to 2.0 mm). The tool faces (the molds for the front and rear surfaces) may be readily replaced within the mold to enable manufacture of a wide range of lens prescriptions with minimum down time.

Affiliated with

Also associated with

Rating

Manufacturing of positive power opthalmic lens does not yet have a rating. At this time, there are no reviews or comments for this patent.

If you have personal experience with Manufacturing of positive power opthalmic lens, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Manufacturing of positive power opthalmic lens will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFCA-PAI-O-1546024