B - Operations – Transporting – 29 – C
Patent
B - Operations, Transporting
29
C
B29C 45/18 (2006.01) B29C 45/00 (2006.01) B29C 45/28 (2006.01) C08K 3/34 (2006.01)
Patent
CA 2340036
Reinforced plastic pellets comprise thermoplastic material and reinforcement particles that are less than 15 % of a total volume of the pellets, and at least 40 % have a thickness of less than 50 nanometers. A manifold (56) has at least two spaced valve gates (64) that are independently opened and closed as directed by a controller (68) to selectively communicate the manifold to a cavity. A primary injection pressure is applied to the plasticized pellet material in the manifold (56) to fill the cavity through sequential opening and closing of the gates (64). A lower secondary injection pressure is applied to the material in the manifold to continue filling the cavity. The gates are closed to seal the manifold from the cavity when the cavity is filled. The material is held within the manifold in compression by the valves while the cavity is open to prevent expansion of the material.
Des pastilles de plastique renforcé comprennent une matière thermoplastique et des particules de renforcement représentant moins de 15 % d'un volume total des pastilles, et au moins 40 % présentent une épaisseur inférieure à 50 nanomètres. Un répartiteur (56) comprend au moins deux obturateurs espacés (64) lesquels sont ouverts et fermés indépendamment sous la commande d'une unité de commande (68) afin de faire communiquer sélectivement le répartiteur et une cavité. Une pression d'injection primaire est appliquée à la matière en pastille plastifiée dans le répartiteur (56) afin de remplir la cavité par l'ouverture et la fermeture séquentielle des obturateurs (64). Une pression d'injection secondaire inférieure est appliquée à la matière se trouvant dans le répartiteur pour continuer le remplissage de la cavité. Les obturateurs sont fermés afin d'obturer le répartiteur par rapport à la cavité lorsque celle-ci est remplie. La matière est contenue dans le répartiteur en compression par les obturateurs tandis que la cavité est ouverte pour empêcher la dilatation de la matière.
Brandt Kerstin B.
Magna International Of America Inc.
LandOfFree
Method of molding large thin parts from reinforced plastic... does not yet have a rating. At this time, there are no reviews or comments for this patent.
If you have personal experience with Method of molding large thin parts from reinforced plastic..., we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Method of molding large thin parts from reinforced plastic... will most certainly appreciate the feedback.
Profile ID: LFCA-PAI-O-1495523